LIMITED OFFER: Save $200 Today! - Get All Themes For $199 -- Learn More

Ask the community

This is a community support forum where you can ask
questions and interact with other PremiumPress Customers.

Export/Import

  • Peter
    Peter
    Newbie 36 points
    November 24, 2016 at 8:15 pm

    Hello all,

    I’m not sure if this is possible (I really hope so!) I have an old site built in Shopperpress ver. 6.7 (there are a lot of products on there) and I’d like to export all the products onto my new site – Responsive ver. 8.9.6

    The old website address is http://www.southertonguns.com and the new site is located at http://www.itsfirst.co.uk

    I’ve tried using the PremiumPress Post Transfer tool following the instructions but I can’t get it to transfer the products as I thought it would!

    Any help would be very much appreciated!

    Pete


  • Josh
    Super Guru 13,885 points
    November 25, 2016 at 1:03 pm

    Hello Pete,
    Have you tried using the CSV Spreadsheet Import Plugin >>http://www.premiumpress.com/plugin/csv/

  • Peter
    Peter
    Newbie 36 points
    November 25, 2016 at 8:19 pm

    Hello Josh,

    Thank you once AGAIN for your prompt response! I’ll try this over the weekend,

    Pete

  • Peter
    Peter
    Newbie 36 points
    November 26, 2016 at 8:32 pm

    Hello Josh,

    Many thanks for your support but when I install the CSV plugin it is visible in the responsive theme (in the left column as ‘CSV import’) but it’s not visible the old theme, yet it does show that the plugin is actually installed,

    Thanks once again!

    Pete

  • Errol
    Errol
    Super Guru 2,708 points
    November 29, 2016 at 7:00 am

    @Peter you may have to use the transfer plugin, back up your sites first just in case – I have not seen that version in over 3 yrs :) I believe, however the site still looks great – Good Luck – Here goes…

    PremiumPress Transfer Tool

  • Peter
    Peter
    Newbie 36 points
    November 29, 2016 at 7:48 pm

    Hi Errol,
    Many thanks for your support, I’ll give it a go tomorrow!
    Pete.

  • Peter
    Peter
    Newbie 36 points
    December 14, 2016 at 7:37 pm

    Hi Errol,

    Many thanks for your support, I did get it sorted eventually – actually partially using the transfer tool then adding the images. Thanks again!

    Pete


  • Josh
    Super Guru 13,885 points
    December 15, 2016 at 3:01 pm

    Thanks for updating Peter :)

  • Errol
    Errol
    Super Guru 2,708 points
    December 18, 2016 at 2:26 am

    :) Nice to hear Peter, just stay focus and with a bit of patience you’ll get there. Thanks Josh for your assistance on the forum.

    Kind Regards

Viewing 9 posts - 1 through 9 (of 9 total)